Thursday, November 13, 2008

Dome Ring and Component Plates

I have been working on R2 in the evenings over the last few days and I was finally able to get the HDPE ring and lower ring installed on my 300mm dome.













I also continued work on my "Component Plates" that will be mounted inside the dome. Each plate holds the components for the dome (HP's, Logics, PSIs ,etc.) in either the front or the back. Theoretically this makes it easier to install and remove things for working on them and maintaining them later.

Below you can see the various component holes cut from the plates and how the plates fit in the dome.


No comments: